Universal Custom File Bars for Steel onstructed Filing Cabinets

Wizard Make Your Own Custom
File Bar, File Rod

Designed to work in all Steel constructed lateral filing cabinets.
Not to be used for Wood cabinets with wood drawers.
(See 742 for Wood Cabinet File Bars)

Wizard Custom File Bars and File Rails are for side to side filing
as well as front to back filing.

Wizard Custom File Bar System
#WFB40
40" Long x 1-1/2" high
Galvanized Steel
$10.34 ea.

Qty

Wizard File Clip
#WFC41
$2.96 ea

Qty

Wizard File Bars or File Rails are available to be cut to your specifications.
Call for quantity pricing and cutting charges.

Note* Please use care in handling and preparation.
Rods may have some burring on the initial cuts.

Example
Drawer Size from wall to wall	Bar Size
27	26-7/8
30	29-7/8
33	32-7/8
39	38-7/8

Cutting Instructions

A- For Side-to-Side filing
Measure the inside distance from drawer wall to drawer wall. Then subtract 1/8" for the actual bar length. (see table as example)
Each clip takes up 1/16" (see above)
Cut the rod to the required dimension using a hack saw, chop saw or band saw.
If needed, use a file or piece of fine grit sandpaper to knock off any burr that may occur.

B-For Front-to-Back
First determine if there is a lip or edge that the clip can attach to. If so, the above instructions apply here also.
If not, than you must first create a side-to-side filing bar it now becomes the edge that the front-to-back bar attaches to.
*Don't forget to remove any sharp edges with a file.

When cutting your file bar or rail, Safety First.